Nortel Meridian
Join now to read essay Nortel Meridian
INPUT/OUTPUT CRASH COURSE
Meridian crash course
faq798-5880
Posted: 20 May 05 (Edited 3 Jun 05)
Programming Meridian SL1 PBX
This is a short introduction into programming a Meridian PBX. The Meridian PBXs software divides information into LOADS. Each Load has a specific function for example. LD 20 is where you can print information about phones. The loads range from LD 01 – LD 143
How to HyperTerminal in to the PBX and VOICEMAIL Systems.
1. Launch HyperTerminal
2. Set phone number to your modem dialin number
3. Set terminal emulation to VT102 X Modem
4. Dial… it should end up at a blank HyperTerminal window
5. Type the password to access the PBX modem. This will not show up on the screen when you type it. The screen should now display “Ok, You are now transparent to port 1”.
6. Type “logi” to login, then the password.
7. You should now have a > command prompt.
To go from PBX commands to VOICEMAIL